PME CARTRIDGE for Injection applications

For the installation into the mould with radial or axial water discharge

The injector types 00144 radial and 00146 axial are characterized through their compactness. This offers a fix installation starting from the parting line to an installation opening situated in the mould. All media connections are carried out via drillings that feed radially to the injector in the mould.

Injector CARTRIDGE Type 00144 radial

The injector type is used for the manufacturing of components where the fluid is to be injected in the sprue or the injector is to be placed into the component.
 
Injector Type 00144 radial
 
The water discharge is carried out radially on the level of the parting line.
Dimensions: approx. Ø 45 x 180 mm
Dimensions with end switch holder: Ø approx. 45 x 270 mm
 
 

Injector CARTRIDGE Type 00146 axial and thermally decoupled

This injector type is used to manufacture components where the fluid is to be injected in the sprue or the injector is to be placed directly into the component as well as for small media pipes with a channel end plane to the mould parting line. To prevent a formation of an excessive thick surface layer of the melt in front of the injection needle, the injector cartridge is equipped with a teflon head for thermal isolation.
 
Injector Type 00146 axial and thermally decoupled
 
The water discharge is carried out axially on the level of the parting line.
Needle Ø: 8 mm
Dimensions: approx. Ø 45 x 166 mm
Dimensions with end switch holder: approx. Ø 45 x 260 mm
 

© 2014 - PMEfluidtec